Windows 98 Setup Instructions
1. Set Up a Dial-Up Networking Connection. |
1. Click on "My Computer"
2. Click on "Dial-Up Networking
| If this is your first time to Dial-Up Networking, a "wizard" will start, and ask a few simple questions. Use these instructions as a guide to answer those questions. If it doesn't work, start over at step #1. |
3. You should see only 1 icon: "Make New Connection" (If you have any
unwanted or non-working icons, just RIGHT-Click on each, click "Delete,"
and click "Yes")
4. Double-click on "Make New Connection."
5. Type a name for the computer you are dialing -- "Show-Me
Net"
6. Enter the area code "573" and phone number. DO NOT CALL LONG DISTANCE!
Jackson 204-0040 |
Advance 722-3422 |
7. Click "Finish."
2. Fine Tune the Connection. |
1. RIGHT-Click on Show-Me Net's icon in Dial-Up Networking.
2. Left Click on "Properties"
The ONLY changes or additions necessary are:
-- REMOVE the check mark in the box next to: "Use area code and dialing properties."
-- Verify that the "Connect using:" box lists your modem. If in doubt, assume it is correct.
-- NEVER click on the "Configure:" button and change anything!
3. Enter Your User Name & Password |
1. DOUBLE-click the Show-Me Net icon in Dial-Up Networking.
2. Enter your User ID in the "User name" field. USE ALL LOWER CASE LETTERS!
3. Enter your password in the "Password" field. CAPITALIZATION IS IMPORTANT
This page was last modified
December 11, 2006
http://www.showme.net/helpdesk/setup98.htm